IC8.hex - MiniBOX (Simple LocoNet Command Station) main logic
IC4.hex - DCC Generator


CHANGELOG
---------
Revision 1.77  2011/08/29 15:37:14  paolsen
 new:
   - Added show device id on reconnect (on sl_wr_data)
   - Using CCP1 toghter with timer 1 to handle cd-backoff timing, making HW CD-timer superfluous (for LN-timing, but still in use by ACK-detector)
 changes:
   - Changed FASTBLINK/VERYFAST for full/in-use slot
 bugfix:


Revision 1.65  2011/04/01 18:37:04  paolsen
 new:
   * Added copyright info to EEROM space
 change:
   * Init display with 8888
   * Showing underline not minus when dispatch stack empty
 bugfix:
   * Reimplement Slot Write Accepted LACK(1) => LACK(7F) as it turned out to be a very bad idea since Digitrax cabs don't connect


Rev 1.47 2006/04/11 23:43:01 paolsen
 new:
   - Increased capacity to 8 refresh slots
   - Possible to choose 28FS when entering loco address
   - Support FAST_CLOCK slot, but not running it
   - Support GlobalPowerOn LocoNet-command (GPON)
 change:
   - New loco refresh algorithm
   - Improved 28FS DCC packet generator
   - Slot write (OPC_WR_SL_DATA) to legal slot respond with LACK(1) (as implemented by JMRI)
   - Slot write (OPC_WR_SL_DATA) to PROG_SLOT gives immediate LACK(7F)
 bugfix:
   - Allow Dispatch Put IN_USE slots, but set to COMMON
   - Request (OPC_RQ_SL_DATA) for unsupported slot respond with LACK(7F)
   - Workaround for Daisy in FRED mode (changed response of request for slot 0)


Rev 1.23  2005/11/08 22:48:19  paolsen
 - new:    supporting GlobalPowerOff LN-command
 - change: increased purge time to 75 s (matching UT1)
 - fixed:  better support of Digitrax throttle - tested with UT1


Rev 1.22  2005/10/11 20:00:41  paolsen
 - bugfix: reconnect after address purged could cause loco in several slots


Rev 1.18  2005/01/23 20:19:32  paolsen
 - bugfix: corrected the 28FS (and 14FS) algorithm
 - change: increased default purge time to 64 seconds
	


(C) 2003 PaoDesign (paolsen@start.no)